EN 397:2012 Compression Testing Industrial Safety Helmets
This European standard specifies the physical and performance requirements, methods of test, and marking requirements for industrial safety helmets for general use in industry. Industrial safety helmets are intended primarily to provide protection to the wearer against falling objects and consequential brain injury and skull fracture.
When tested by the method given in section 6.11, the maximum lateral deformation of the helmet shall not exceed 40 mm, and the residual lateral deformation shall not exceed 15 mm. The extent of damage inflicted, if any, should be noted.
The test procedure is set up using Bluehill® TestProfiler to build the ramps and dwell times required in the loading sequence profile as described below. The helmet is placed transversely between rigid parallel compression platens.
An initial force of 30 N is applied perpendicular to the platens so that the helmet is subjected to a lateral force. After 30 seconds the distance between the compression platens shall be measured (dimension x).
The force is then increased up to 430 N, which is held for 30 seconds, after which the distance between the platens shall again be measured (dimension y).
Finally, the force is decreased to 25 N and then immediately increased to 30 N, which is held for 30 seconds, after which the distance between the platens shall again be measured (dimension z).
Bluehill Expression builder is used to simply create the below custom calculations.
- The maximum lateral deformation is the difference between dimensions x and y
- The residual lateral deformation is the difference between dimensions x and z
It is suggested to use a standard Dual-Column Tabletop Frame in conjunction with compression platens.
The Bluehill® Software package is used to input specimen parameters, set the desired speed control, automatically calculate the desired results and statistics, and to produce a test report.
It is important to review EN 397 in order to fully understand the test setup, procedure, and results requirements.
- 108.6 KB
Bluehill Universal Software is built from the ground-up for touch interaction and an intuitive user experience. Discover simpler and smarter testing with features such as pre-loaded test methods, QuickTest in seconds, enhanced data exporting: and Instron Connect – a new feature that provides a direct communication link to Service. Users of previous versions of software such as Bluehill 2 and Bluehill 3 can easily upgrade to the newest version of Bluehill.
- 1.4 MB
5900 Universal Testing Systems are engineered for precision, built for durability, and offer the flexibility for changing requirements. They are designed with standard and optional features that increase testing efficiency and improve the testing experience for the operator. A wide range of models are available for testing capacities from < 100N up to 600kN.
- 2.8 MB
Instron 3300 Series Universal Testing Systems for Tensile, Compression, Bend, and other material property tests.
- 2.2 MB